By Rae Holmes. Furniture. Published at Friday, November 03rd, 2017 - 14:00:05 PM.
Wood veneers can be difficult to match. It is possible to buy new veneer strips, but they are generally thinner than the old hand-sawn veneers and do not always match in colour. It often pays to go to an auction to look for a broken oddment of furniture that has suitable veneers. To remove a veneer from its backing, first clean off any old polish with white spirit and carefully clean the varnish or wax. Place a damp cloth over the cleaned strip and press with a fairly hot iron. Keep the cloth damp. This melts the Scotch glue holding down the veneer, which can then be peeled off. The same technique is used to raise small areas on the antique piece, but use a soldering iron instead of an iron. Wipe all traces of glue while it is still warm. Dampen the veneer and flatten it between two pieces of wood for about 24 hours before use. Do not let it dry completely, for veneers must be re-laid while still damp and pliable. The replacement veneer should be slightly thicker than the existing one, to allow for sanding. Stick the new strip down with Scotch glue and apply a weight or clamp until the glue has completely set. Wax and polish to match the existing finish.
Most of the clout natural materials hold as bases for both indoor and outdoor furniture stem from their long production history. Some of the fibres used to produce outdoor furniture in the 21st century are exactly the same used by the Ancient Egyptians when they first began using the technique of weaving, several centuries before Christ. This traditional aspect is appealing to most home-owners, and goes a long way towards explaining the significant popularity these materials continue to enjoy to this day.
Finding suitable replacement materials for inlay and boulle antiques is an even greater problem. They tend to use more complex and varied materials. Antique and second-hand shops often have boxes containing suitable oddments and it is worth searching through them to find matching pieces. As a last resort, missing pieces of inlay can be built up with synthetic resins or wax, coloured to match. If boulle has lifted seriously or is bent, leave the repair to an expert restorer; but if the lifting is only slight, carefully remove the section and scrape clean all the dirt. Stick with an epoxy resin adhesive and weight it down until the glue has dried.
Any content, trademark’s, or other material that might be found on the Netplay website that is not Netplay’s property remains the copyright of its respective owner/s. In no way does Netplay claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 Netplay. All Rights Reserved.